AEG HK654200IB User Manual

Also see for HK654200IB: User manual

Contents

Problem Possible cause and remedyThe Automatic Heat Up func-tion does not operate.• There is still residual heat on the cooking zone. Let the cookingzone become sufficiently cool.• The highest heat setting is set. The highest heat setting has thesame power as the Automatic Heat Up function.The heat setting changes be-tween two levels.The Power management is activated. See the section Power man-agement.The sensor fields become hot. The cookware is too large or you out it too near to the controls.Put large cookware on the rear cooking zones if it is necessary.There is no signal when youtouch the panel sensor fields.The signals are deactivated. Activate the signals (see OffSoundControl).comes on The Automatic Switch Off operates. Deactivate the appliance andactivate it again.comes on • No cookware on the cooking zone. Put cookware on the cook-ing zone.• Not correct cookware. Use the correct cookware.• The diameter of the bottom of the cookware is too small forthe cooking zone. Move cookware to a smaller cooking zone.and number comes on. There is an error in the appliance.Disconnect the appliance from the electrical supply for sometime. Disconnect the fuse from the electrical system of the house.Connect again. If comes on again, speak to the service centre.comes on There is an error in the appliance, because a cookware boils dry oryou use not correct cookware. The protection against become toohot for the cooking zone operates. The Automatic Switch Off op-erates.Deactivate the appliance. Remove the hot cookware. After, ap-proximately 30 seconds activate the cooking zone again.should go out of the display, residual heat indicator can stay. Letthe cookware become sufficiently cool and check it with the sec-tion Cookware for the induction cooking zone.If you tried the above solutions and cannot repair the problem, speak to your dealer or thecustomer service. Give the data from the rating plate, three digit letter code for the glassceramic (it is in the corner of the glass surface) and an error message that comes on.Make sure, you operated the appliance correctly. If not the servicing by a customer servicetechnician or dealer will not be free of charge, also during the warranty period. The instruc-tions about the customer service and conditions of guarantee are in the guarantee booklet.ENVIRONMENT CONCERNSThe symbol on the product or on its packaging indicates that this product may not betreated as household waste. Instead it should be taken to the appropriate collection pointfor the recycling of electrical and electronic equipment. By ensuring this product isdisposed of correctly, you will help prevent potential negative consequences for the16 Environment concerns