AEG PROTECT C. 10000 Operating Instructions Manual

Contents

32are recommended. In the sub distribution the followingindications are necessary:♦ Maximal total load♦ Maximal total load for the separate load power circuitsi In the case of one common distributor cabinets(Circuits for mains and UPS power) each has tobe labelled separately (Mains or UPS).5.3.4 Connection of the loadsTo protect the personnel during installation, ensure that theconnection takes place und the following precautions:♦ No mains power present.♦ Loads are switched of.♦ The PROTECT C. is switched of (display completelyoff).To activate the PROTECT C. execute the following steps:♦ Set manual bypass „Maintenance Switch“ to “Bypass”on the rear of the UPS. Remove the four screws of thecover (Pos. 2, page 26).♦ Set the mains input circuit breaker (Pos. 3, page 26) toposition “OFF”Connect the “OUTPUT” of the UPS with the associatedterminals./ PE = GroundN = Neutral lineL = Phase5.4 External Battery ExpansionsTo achieve longer backup time, it is possible to connect multi-battery packs. Connect exclusively the following productstogether:PROTECT C. 6000 with PROTECT C. 6000 BPPROTECT C. 10000 with PROTECT C. 10000 BP