AEG X89384MD01 User Manual

5ENGlishfunction without lifting it off. If the motor andlights are turned off, by setting them to zero,all the command leDs will remain on at50%, and if no further commands are givenin the next 10 seconds, then all the leDswill be turned off with the exception of the “0”leDs, which will remain on for a further 15minutes.5. HOOD OPTIOns In sensOr MODeWhen operating in sensor mode, the typeof hob being used has an influence. Twooptions are available:Electric hob;Gas hob;Initially it is set to electric hob. To change thesetting, proceed as follows:• Turn the hood off using the hood on/offbutton• Press and hold the sensor button for8 seconds until the LED flashes asdescribed:- 4 flashes indicate selection of theelectric hob;- 2 flashes indicate selection of the gashob;• remove power for 10 seconds and thenreconnect it.The calibration procedure is carried outevery time the type of hob is changed.Calibration procedure: every time thehood is turned on or the type of hob ischanged, the sensor calibration procedureis run. During this time the hood must not beused for cooking or subjected to particularlyintense smells, for example solvents ordetergents.This process requires:• 13 minutes if the electric hob has beenselected;• 1 minute if the gas hob has been selected;This phase is marked by flashing of the LEDon the sensor button, if it has been pressed.Do not turn the motor on during calibration.Warning: Do not spray directly on the grillcleaning products but only clean with acloth soaked in detergent. avoid cleaningthe grill alcohol or silicone products.6. lIGHTInGWarning: This appliance is fitted with awhite leD lamp classed as 1M accordingto en 60825-1: 1994 + a1:2002 + a2:2001standards; maximum optical power emitted@439nm: 7μW. Do not look directly at thelight through optical devices (binoculars,magnifying glasses…).• For replacement contact technicalsupport. (“To purchase contact technicalsupport”).