2thank you for purchasing our spring loaded 10A test probes. these test probes are designed for usewith aeMc® Micro-ohmmeters Model 6240 and 6250 or equivalent.For best results from your instrument: read these operating instructions carefully, comply with the precautions for use.Warning, risk of danger! the operator must refer to these instructions whenever thisdanger symbol appears.the ce marking indicates conformity with the european lVd and eMc directives.in the european union, this product is subject to a separate collection system for recyclingelectrical and electronic components in accordance with directive Weee 2002/96/ecDefinition of measurement categories: Measurement category iV corresponds to measurements taken at the source of low-voltage installations.example: power feeders, counters and protection devices. Measurement category iii corresponds to measurements on building installations.example: distribution panel, circuit-breakers, machines or fixed industrial devices. Measurement category ii corresponds to measurements taken on circuits directly connected to low-voltage installations.example: power supply to electro-domestic devices and portable tools.PREcAUtIONS FOR USEthe protection of this accessory can be compromised if it is used in a way that is not recommended bythe manufacturer. observe the maximum voltage, intensity and measurement category. do not use the accessory on networkswhere the voltage or category exceeds those stated in this manual. observe the conditions of use (e.g. temperature, humidity, altitude, degree of pollution and location of use). do not use the accessory if it is open, damaged or incorrectly reassembled. any repairs must be carried out by skilled and approved personnel.ENGLISHwww. .com information@itm.com1.800.561.8187