Line Keys and Softkeys55 41-001452-00 Rev 00 – 07.2011State-Based Softkeys (Bottom Keys only)On the 6737i bottom softkeys, you can configure a specific state to display when a softkey is being used.The following table describes the states available to configure for the softkeys.The following table identifies the applicable default states for each softkey type on the IP phone.State Descriptionidle The phone is not being used.connected The current line is in an active call (or the call is on hold).incoming The phone is ringing.outgoing The user is dialing a number, or the far-end is ringing.busy The current line is busy because the line is in use or the line is set as “Do Not Disturb”.Softkey Type Default StatesNone All states disabled.Line idle, connected, incoming, outgoing, busySpeed Dial idle, connected, incoming, outgoing, busyDND idle, connected, incoming, outgoing, busyBLF idle, connected, incoming, outgoing, busyBLF List idle, connected, incoming, outgoing, busyAuto Call Distribution (ACD) idleDirected Call Pickup (DCP)Group Call Pickup (GCP)idle, connected, incoming, outgoing, busyXML idle, connected, incoming, outgoing, busyFlash All states disabled.Sprecode connectedPark connectedPickup idle, outgoingLast Call Return idle, connected, incoming, outgoing, busySoftkeys(state-based)NoneNoneNoneNoneNoneNoneVoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
