Abatron BDI2000 Installation Manual
Also see for BDI2000: Installation manualUser manualsUser manualUser manualUser manual
                      | |
Contents
| 
bdi AccessJTAG interface library, BDI2000 (MIPS32)Installation Manual 7© Copyright 1992-2004 by ABATRON AG V 1.002.2 Connecting the BDI2000 to Power Supply2.2.1 External Power SupplyThe BDI2000 needs to be supplied with 5 Volts (max. 1A) via the BDI OPTION connector (Rev. A)or via POWER connector (Rev. B/C). The available power supply from Abatron (option) or the en-closed power cable can be directly connected. In order to ensure reliable operation of the BDI2000,keep the power supply cable as short as possible.For error-free operation, the power supply to the BDI2000 must be between 4.75V and 5.25V DC.The maximal tolerable supply voltage is 5.25 VDC. Any higher voltage or a wrong polaritymight destroy the electronics.Please switch on the system in the following sequence:• 1 --> external power supply• 2 --> target system!BDI TRGT MODE BDI MAIN BDI OPTION13 114 2BDI OPTION1 - NOT USED2 - GROUND3 - NOT USED4 - GROUND5 - NOT USED6 - GROUND7 - NOT USED8 - GROUND9 - NOT USED10 - GROUND11 - NOT USED12 - Vcc (+5V)13 - Vcc Target (+5V)14 - Vcc (+5V)Vcc GNDConnectorThe green LED «BDI» marked light up when 5V power is connected to the BDI2000Rev. ABDI TRGT MODE TARGET A TARGET BPOWER1 - Vcc (+5V)2 - VccTGT3 - GROUND4 - NOT USEDConnectorThe green LED «BDI» marked light up when 5V power is connected to the BDI2000RS232 POWER LI TX RX 10 BASE-T1 Vcc2GND 34Rev. B VersionRev. B/C |
Related manuals for Abatron BDI2000
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine