Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Abatron BDI2000 Installation Manual

Also see for BDI2000: Installation manualUser manualsUser manualUser manualUser manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Contents
  1. Table Of Contents
  2. Introduction
  3. Installation
  4. Changing Target Processor Type
  5. Connecting the BDI2000 to Power Supply
  6. Status LED «MODE
  7. Connecting the BDI2000 to the Host
  8. Ethernet communication
  9. Installation of the bdiAccess Software
  10. BDI2000 Setup/Update
  11. Windows Hosts
  12. Recover procedure
  13. Specifications
  14. Environmental notice
  15. Warranty
  16. A Troubleshooting
  17. B Maintenance
  18. C Trademarks
Abatron BDI2000 Installation Manual Manual pdf 9 page image
bdi Access JTAG interface library, BDI2000 (PPC6xx/7xx/82xx/83xx) Installation Manual 9© Copyright 1992-2009 by ABATRON AG V 1.122.4 Connecting the BDI2000 to the Host2.4.1 Serial line communicationThe host is connected to the BDI through the serial interface (COM1...COM4). The communicationcable between BDI and Host is a serial cable (RXD / TXD are crossed). There is the same connectorpinout for the BDI and for the Host side (Refer to Figure below).RS232 Connector(for PC host)BDI2000Target SystemRS232PC Host1 - NC2 - RXD data from host3 - TXD data to host4 - NC5 - GROUND6 - NC7 - NC8 - NC9 - NCRS232 POWER LI TX RX 10 BASE-T543219876PPC
/ 21
This manual is suitable for:
BDI2000
Manuals database logo
manualsdatabase
Your AI-powered manual search engine