Abatron BDI2000 User Manual
Also see for BDI2000: Installation manualInstallation manualUser manualsUser manualUser manual
                              | |
Contents
| 
bdi NDIJTAG debug interface for EDGE Debugger, BDI2000 (PPC6xx/7xx/82xx/83xx) User Manual 12© Copyright 1992-2007 by ABATRON AG V 1.012.6 ConfigurationBefore you can use the BDI together with the debugger, the BDI must be configured. Use theSETUPmenu and follow the steps listed below:• Load or update the firmware / logic, store IP address -->Firmware• Set the communication parameters between Host and BDI -->Communication• Setup an initialization list for the target processor -->Initlist• Select the working mode -->Mode• Transmit the configuration to the BDI -->Mode TransmitFor information about the dialogs and menus use the help system (F1).2.6.1 BDI2000 Setup/UpdateFirst make sure that the BDI is properly connected (see Chapter 2.1 to 2.4). The BDI must be con-nected via RS232 to the Windows host.To avoid data line conflicts, the BDI2000 must be disconnected from the target system whileprogramming the logic for an other target CPU (see Chapter 2.1.1).The following dialogbox is used to check or update the BDI firmware and logic and to set the networkparameters.dialog box «BDI2000 Update/Setup»The following options allow you to check or update the BDI firmware and logic and to set the networkparameters:Channel Select the communication port where the BDI2000 is connected duringthis setup session.Baudrate Select the baudrate used to communicate with the BDI2000 loader duringthis setup session.! |
Related manuals for Abatron BDI2000
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine