Abatron bdiWind PowerPC MPC8xx User Manual
                                                         | |
Contents
| 
bdi Windfor Tornado™, BDI2000 (MPC8xx/MPC5xx)User Manual 10© Copyright 1997-2007 by ABATRON AG Switzerland V 1.382.2.2 Power Supply from Target SystemThe BDI2000 needs to be supplied with 5 Volts (max. 1A) via BDI MAIN target connector (Rev. A) orvia TARGET A connector (Rev. B/C). This mode can only be used when the target system runs with5V and the pin «Vcc Target» is able to deliver a current up to 1A@5V. For pin description and layoutsee chapter 2.1 «Connecting the BDI2000 to Target». Insert the enclosed Jumper as shown in figurebelow. Please ensure that the jumper is inserted correctly.For error-free operation, the power supply to the BDI2000 must be between 4.75V and 5.25V DC.The maximal tolerable supply voltage is 5.25 VDC. Any higher voltage or a wrong polaritymight destroy the electronics.!BDI TRGT MODE BDI MAIN BDI OPTION13 114 2BDI OPTIONConnectorThe green LEDs «BDI» and «TRGT» marked light up when target is powered upJumperand the jumper is inserted correctly1 - NOT USED2 - GROUND3 - NOT USED4 - GROUND5 - NOT USED6 - GROUND7 - NOT USED8 - GROUND9 - NOT USED10 - GROUND11 - NOT USED12 - Vcc (+5V)13 - Vcc Target (+5V)14 - Vcc BDI2000 (+5V)Rev. ABDI TRGT MODE TARGET A TARGET BPOWER1 - Vcc BDI2000 (+5V)2 - Vcc Target (+5V)3 - GROUND4 - NOT USEDConnectorRS232 POWER LI TX RX 10 BASE-T1234The green LEDs «BDI» and «TRGT» marked light up when target is powered upand the jumper is inserted correctlyJumperRev. B/C |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine