CODE XXXCODEAbSensor Pack | Envase del sensorCustomer Service | Atención al clien1-855-632-8658XXXXXXXXXXXXXXYYYY-MM-DDFreeStyleLibSTEP 3STEP 6STEP 9Get ReadyApply Sensor Prepare Sensor ApplicatorWash site using a plain soap,dry, and then clean with alcoholwipe. Allow site to air dry beforeproceeding.Peel lid completely off Sensor Pack.Unscrew cap from Sensor Applicator.CAUTION: Sensor codesmust match on Sensor Packand Sensor Applicator orglucose readings will beincorrect.Refer to your User’s Manual for full System instructions and information.TouchscreenHome ButtonUSB PortSensorPackReaderPlace Sensor Applicator over siteand push down firmly to applySensor.CAUTION: Do not push down onSensor Applicator until placedover prepared site to preventunintended results or injury.Make sure Sensor is secure.Discard used Sensor Applicatorand Sensor Pack according tolocal regulations.Gently pull Sensor Applicatoraway from your body.Quick Start Guide forFreeStyle Libre 2 ReaderSTEP 1STEP 4STEP 7STEP 2STEP 5STEP 8Line up dark mark on SensorApplicator with dark mark onSensor Pack. On a hard surface,press down firmly on SensorApplicator until it comes to a stop.Sensor Applicator is ready toapply Sensor.CAUTION: Sensor Applicatornow contains a needle. Do nottouch inside Sensor Applicatoror put it back into Sensor Pack.Lift Sensor Applicator out ofSensor Pack.Lid CapSensorSensorApplicatorCodes on labelsmust match●1 Assemble and ApplySensor to your body●2 Start new Sensor with Reader●3 Check your glucose whenever youwant for up to 14 days.Wait 60 minutesfor start-upSelect site on back of upper arm.Do not use other sites as these mayresult in inaccurate glucose readings.Note: Avoid scars, moles, stretchmarks, lumps, and insulin injectionsites. To prevent skin irritation,rotate sites between applications.Setup Overview●1 Assemble and Apply Sensor to the back of your upper armFLASH GLUCOSE MONITORING SYSTEM