Abbott Precision XceedPro Operator's Manual

Contents

Abbott Precision XceedPro Operator's Manual Manual pdf 78 page image

Chapter 12: Specifications/LimitationsRSS:RSS is an abbreviation for Reduced Symbology Set, which produces very small barcodes suitable for labelingelectronic components and healthcare devices. There are seven different types of RSS barcodes. RSS can encode atmaximum 74 characters.Note: Control characters and non-alphanumeric characters (e.g. $) are displayed as spaces in the PrecisionXceed Pro Monitor. Some barcodes may contain control characters and non-alphanumeric characters.The Barcode Type section of the MeterCom screen allows you to set all barcode data entry options for theOperator ID. and Patient ID. The types of barcodes selected determine what codes can be scanned into theMonitor. Refer to the Meter Component Manual for detailed information.Important Safety InstructionsDANGER• Misuse of electrical equipment can cause electrocution, burns, fire and other HAZARDS.• Basic safety precautions should always be taken, including all those listed below.• Close supervision is necessary when equipment is used by, on, or near children, handicapped persons or invalids.READ THIS BEFORE USING THE EQUIPMENT• Do not place the equipment in liquid, nor put it where it could fall into liquid.• Use the equipment only for the purpose described in the instructions for use.• Do not use accessories which are not supplied or recommended by the manufacturer.• Do not use the equipment if it is not working properly, or if it has suffered any damage.• NOTE Examples of typical defects include:• damage caused by dropping the equipment.• damage caused by dropping the equipment into water or splashing water onto it.• Do not let the equipment come into contact with surfaces which are too hot to touch.• Do not place anything on top of the equipment.• Unless specifically instructed to do so by the instructions for use, do not drop or put anything into any opening inthe equipment.• Do not use the equipment out of doors.KEEP THESE INSTRUCTIONSSignal Output and Signal Input PartsThe following is recommended by UL for the “Intended signal input and signal output connections complying with thisrequirement.” (UL 60601-1-1st edition)The use of ACCESSORY equipment not complying with the equivalent safety requirements of this equipment may leadto a reduced level of safety of the resulting system. Consideration relating to the choice shall include:Use of the accessory in the PATIENT VICINITY.•Evidence that the safety certification of the ACCESSORY has been performed in accordance to the appropriate IEC•601-1 and/or IEC 601-1-1 harmonized national standard.Patient Vicinity (UL 60601-1-1st edition)In areas in which patients are normally cared for, the patient vicinity is the space with surfaces likely to be contactedby the patient or an attendant who can touch the patient. This encloses a space within the room 1.83 m (6 feet) beyondthe perimeter of the bed (examination table, dental chair, treatment booth, and the like) in its intended location, andextending vertically 2.29 meters (7 1/2 feet) above the floor.Other InformationThe device is rated for use in oxygen-rich environments. The device is rated for continuous operation.This device was evaluated against IEC 60601-1-2. Operation of this device may affect or be affected by other equipmentin the vicinity of the device. If an effect is observed, increase the distance between devices.12-4Questions? Refer to Page 10-9 For Technical Support Instructions.

/ 79

Related manuals for Abbott Precision XceedPro