Abelko IMSE Ultra Series User Manual
Also see for IMSE Ultra Series: User manual
                                                   | |
Contents
| 
388.5.4 Front panel buttons for SD-card on UltraBase30At the front of an UltraBase30, there are two buttons to interact with the SD-card without using a PC. You can create and restore system backups, and updatefirmware form a SD.card using these buttons.Note! If someone else is working on the device through the interface, the lightabove the SD card will flash green. Do not touch the SD card or the backupbuttons during this process since it may interrupt their work.Create a system backup with the buttons on the front1. To create a system backup of the systems data to the SD card, holdthe BACKUP button until the light above the SD-card starts to flashgreen.2. The light above the SD-card will flash green during the whole process.3. When the process is complete, the light will shine green for 5seconds. Now the backup is finished.If an error should occur, the light will flash red for 15 minutes. A file will betransferred to the SD card with information concerning the error (as long as thecard is not write-protected).Note! SD-cards are not recommended for long term data storage. It is safer totransfer the backup file to a computer or similar.Load a system backup with the buttons on the frontYou can load a system backup into the system. The backup is usable when you,for example, want to replace an unit and need an exact copy.1. To load a system backup, hold the buttons LOAD + BACKUP until thelight above the SD-card starts to flash green.2. When the process is completed, the light will shine green for 5seconds. Now the full backup is done.If an error should occur, the light will flash red for 15 minutes. A file will betransferred to the SD card with information about the error (as long as the card isnot write-protected). |
Related manuals for Abelko IMSE Ultra Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine