Abicor Binzel ABICUT 25K Operating Instructions Manual

Also see for ABICUT 25K: Operating instructions Operating instructions

Contents

troubleshooting

Abicor Binzel ABICUT 25K Operating Instructions Manual Manual pdf 30 page image

EN - 14 BAL.0173 • 2018-09-2810 Troubleshooting ABICUT 25K/45/754 Check the safety shut-off mechanism’s contact pins to ensure that their spring function isworking properly. If required, clean the protective cap’s contact ring to ensure a reliablecontact. Replace if necessary.ABICOR BINZEL offers factory repair services.10 TroubleshootingPlease observe the attached ‘Warranty’ document. In the event of any doubts and/or problems,please contact your retailer or the manufacturer.DANGERRisk of injury and device damage when handled by unauthorised personsImproper repair work and modifications to the product may lead to serious injuries anddamage to the device. The product warranty will be rendered invalid if work is carried out onthe product by unauthorised persons.• Operating, maintenance, cleaning and repair work must only be carried out by qualifiedpersonnel (in Germany, see TRBS 1203).NOTICE• Please also consult the operating instructions for the welding components, such aswelding torch, robot control, etc.Fault Cause TroubleshootingInsufficient penetration • Pressure drop during cutting • Reset the pressure monitor• Cutting rate too high • Reduce the cutting rate• Tilt angle of the torch too great • Reduce the tilt angle• Material thickness too high • Use a lower material thickness• Equipment parts worn ordamaged• Replace the equipment parts• Output not adjusted • Adjust the outputCutting arc breaks • Cutting rate too low • Increase the cutting rate• Torch clearance too great • Reduce the torch clearance• Material thickness too high • Use a lower material thickness• Output too low • Adjust the outputTab. 8 Troubleshooting