Abit KN9S User Manual
Also see for KN9 SLI: User manual
                                                                        | |
Contents
| 
BIOS SetupKN9 SLI, KN9 Ultra, KN9S 3-153.6 Power Management SetupPhoenix – AwardBIOS CMOS Setup UtilityPower Management SetupACPI Suspend Type S3(Suspend-To-RAM) Item Help- USB Resume from S3 DisabledPower Button Function Instant-OffWake up by PME# of PCI DisabledWake up by On-Chip LAN DisabledWake up by Alarm Disabledx - Day of Month Alarm 0x - Time (hh:mm:ss) Alarm 0: 0 : 0AMD Cool’n’Quiet Control AutoPower On Function Button Onlyx - KB Power On Password Enterx - Hot Key Power On Ctrl-F1Restore on AC Power Loss Power Off↓↑→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General HelpF5: Previous Values F6: Fail-Safe Defaults F7: Optimized DefaultsACPI Suspend TypeThis item selects the type of Suspend mode.[S1(PowerOn-Suspend)]: Enables the Power On Suspend function.[S3(Suspend-To-RAM)]: Enables the Suspend to RAM function.- USB Resume from S3When set to [Enabled], this item allows you to use a USB device to wake up a system that is inthe S3 (STR - Suspend To RAM) state. This item can be configured only if the item “ACPISuspend Type” is set to [S3(STR)].Power Button FunctionThis item selects the method of powering off your system:[Delay 4 Sec.]: Pushing the power button for more than 4 seconds will power off the system.This will prevent the system from powering off in case you accidentally hit or pushed the powerbutton.[Instant-Off]: Pressing and then releasing the power button at once will immediately poweroff the system.Wake up by PME# of PCIWhen set to [Enabled], access through the add-on PCI card can remotely wake up the systemthat was in Soft-Off condition. The PCI card must support the wake up function. |
Related manuals for Abit KN9 SLI
manualsdatabase
Your AI-powered manual search engine