Abit NF8 Series User Manual

Also see for NF8 Series: User manual

Contents

Abit NF8 Series User Manual Manual pdf 11 page image

Hardware Setup 2-32-3. Install System MemoryThis system board provides two 184-pin DDR DIMM slots for DDR 400 memory modules with memoryexpansion size up to 2GB.Bank Memory Module Total MemoryBank 0, 1 (DIMM1) 256MB, 512MB, 1GB 256MB ~ 1GBBank 2, 3 (DIMM2) 256MB, 512MB, 1GB 256MB ~ 1GBTotal System Memory 256MB ~ 2GBNOTE: Usually there is no hardware or BIOS setup require after adding or removing memory modules,but you will have to clear the CMOS memory first if any memory module related problem occurs.Power off the computer and unplug the ACpower cord before installing or removingmemory modules.1. Locate the DIMM slot on the board.2. Hold two edges of the DIMM modulecarefully, keep away of touching itsconnectors.3. Align the notch key on the module with therib on the slot.4. Firmly press the module into the slots until the ejector tabs at both sides of the slot automaticallysnaps into the mounting notch. Do not force the DIMM module in with extra force as the DIMMmodule only fit in one direction.5. To remove the DIMM modules, push the two ejector tabs on the slot outward simultaneously, andthen pull out the DIMM module.ATTENTION: Static electricity can damage the electronic components of the computer or optionalboards. Before starting these procedures, ensure that you are discharged of static electricity by touching agrounded metal object briefly.Userís Manual