Abit WI-2P User Manual

Contents

Abit WI-2P User Manual Manual pdf 59 page image

Driver Installation 4-34.2. Installing Ultra320 SCSI Controller4.2.1.4.2.2.Installing Windows 2000 with an Ultra320 SCSI Controller1. Start your system with the Windows 2000 Boot CD-ROM in theCD-ROM drive. Note: When using a CD-ROM drive to install Windows2000 from the bootable CD-ROM, make sure Bootable CD-ROM supportis enabled. This is done through the System BIOS Setup Utility.2. Press F6 when this message is displayed: “Press F6 if you need to installthird-party SCSI drivers”.3. When prompted, press “S” to supply the new driver.4. Insert the Adaptec Ultra320 FMS driver disk when the setup prompts youto insert the manufacturer supplied disk into drive A, and press Enter.5. The screen displays the adapter drivers supported on the disk. Select“Adaptec Ultra320 SCSI Cards (Win2000)” and continue with the rest ofthe Windows 2000 installation.6. Your system will reboot once more to finish setting up Windows 2000.Installing the Driver when Windows 2000 is Already Installed1. Start Windows 2000. Windows 2000 will automatically discover the newhardware and start the Found New Hardware Wizard to guide you throughthe device driver installation.2. At the Welcome to the Found New Hardware Wizard window, selectNext.3. On the Install Hardware Device Drivers screen, select Display a list of theknown drivers for this device, and click Next.4. Select the Have Disk button. You will be prompted to insert themanufacturer supplied disk. Insert the Adaptec Ultra320 FMS driver diskin your disk drive and enter the following path, then click OK.a:\win20005. Select the Adaptec Ultra320 driver from the list, then click the Nextbutton.6. Click the Next button again to confirm the installation of the driver. Youmay be prompted with this warning message: “The software you are aboutto install does not contain a Microsoft digital signature ...” Ignore theUser’s Manual