Abitana ABI-EV1002S00 Quick Start Manual
110406_ABI-EV1002_QSG_ML.docEnglish Page 5 N.V. abitana S.A.ENGLISHABI-EV1002S00Twisted Pair BroadbandDistribution AmplifierQuick Start Guide1 Package Contents• DIN rail mountable Broadband Amplifier module• Quick Start Guide• 3 Termination plugs ABI-AP1003S00• Power jumper cord ABI-PS1001SPC2 Tools• Level tester ABI-TT1003S12• Spanner 11mm• Flat screw driver max. 5mm x 0.6mm3 IntroductionThe ABI-EV1002S00 is a Broadband Amplifier with one coaxialinput for CATV signal or antenna.The unit has 4 independent RJ45 (Twisted Pair) outputs on thefront.For ease of installation, a Power Level indicator is provided,indicating the safe area of operation for optimal transmission andquality results.A range of Twisted Pair to Coax adapters (with or withoutadjustment, filters,…) is available for installation at the receiverend (i.e. ABI-AC1001S00*).It is possible to connect a Radio by using a Radio adapter (ABI-AC1004S00) or an adaptor without filter.4 ConnectorsP1 P2 P3POWERP4Input to CATV signa lor AntennaOutputs to 4 indepentTV SetsPower AdjustmentGrounding wireABI-EV1002S00Power level a djustment(ABI-AC1001S00)5 PowerLoad ratio for this module = 0,5.Maximum allowed load ratio (sum of the load ratios for all modules) forpower supply ABI-PS1001S11 = 4.6 InstallationPower Off the central ABI-PS1001S11 Power Supply by means of theCircuit Breaker installed in the ‘Comm Center Cabinet’, or byremoving the mains power cord from the Power Supply.1. Make sure the shielding of the Network Interface Unit (NIU)or CATV transition point is properly connected to theprotective ground.2. Open the ‘Comm Center Cabinet’3. Click the ABI-EV1002S00 unit on the metal DIN-rail.4. The ABI-EV1002S00 is supplied with a grounding wire,connected to the input F-connector.This wire (1) must be connected to the protective ground ofthe installation.The following system devices also need to be connected tothe protective ground: The DIN-Rail frame (2) and the Powersupply (3)EV1002PowerSupplyDIN-Rail FramePE10021234DC10155. Provide power to the module using the included powerjumper cord ABI-PS1001SPC. Please consult the manual ofthe power supply for more information concerning theinstallation of the power supply.6. Connect a coax cable from the CATV connection point (NIU)or the CATV transition point to the coax connector on the topof the unit..Failing to follow the instructions (1) to (6) in the specified ordermay lead to permanent damage of the ABI-EV1002S00 amplifierWhen it is impossible to connect the DIN rails ,frame or CATVtransition point to ground, make sure they are at least at the sameelectrical level (connected to each other). |
Related manuals for Abitana ABI-EV1002S00
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine