Able 2 SHO-ME 02.6100A Installation And Maintenance Instructions Manual
   | |
Contents | 
Installation InstructionsAll connections are external. There is no need to open the control box during the installation process.1. Remove dust cover by removing the two lock nuts and washers located on the back of thearrow board.2. Mount the SHO-ME Directional Arrow Board on the vehicle as desired.3. Replace dust cover.4. Route the cable from the Arrow Board to the driver's compartment or wherever the control boxwill be located.5. A mounting bracket is provided for easy installation of the control box. Determine a suitableposition for the mounting bracket and attach it to the vehicle with appropriate fasteners.6. Connect bare end of the heavy black wire to a suitable chassis ground.7. Connect spade connector of heavy black wire to screw marked "NEG" on the terminal striplocated on the back of the controller.8. Connect spade connector of white wire from the arrow board cable to screw marked "W" onthe terminal strip.9. Connect spade connector of red wire from the arrow board cable to screw marked "R" on theterminal strip.10. Connect spade connector of black wire from the arrow board cable to screw marked "B" on theterminal strip.11. Connect spade connector of green wire from the arrow board cable to screw marked "G" onthe terminal strip.12. Connect spade connector of heavy red wire to screw marked "POS" on the terminal striplocated on the back of the controller.13. Connect bare end of the heavy red wire to a 12-volt positive power source.Note: The above wiring connection instructions assume that the arrow board is mounted facing the rearof the vehicle with the Arrow Board's mounting flange at the bottom position. If the arrow board isinstalled facing the front of the vehicle or in a position with the flange up, the arrow board will not point inthe same direction as the pilot lights on the controller indicate. If the arrow board points right when thecontroller indicates that it is pointing left and vice versa, the situation can be corrected by connecting thewhite wire to the terminal marked "G" and the green wire to the terminal marked "W".After completing the connections, check which direction the arrow board is flashing and be sure that itcoincides with the direction indicated by the control box.Maintenance InstructionsTrouble Shooting1. If arrow board is not operating or is not lighting to full brilliance, make sure all wire connectionsare properly made and the power source is active. Take particular care in making certain thatground connections are properly made.2. If individual lamps in the arrow board are not operating properly, but the bulb is good, tightenthe lamp retaining screws since these screws complete the electrical connections.RRevised 5-07 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine