Quick Start GuideFriction Knob UMS Mounting Armwww.ablenetinc.com(800) 322-0956PN 98000035 (04/19 Rev. F)Getting Started1. Attach clamp to secure surface2. Loosen locking screw on clamp. Press the armrelease button on the clamp and insert themounting arm into the clamp. Tighten lockingscrew on clamp to secure mounting arm.3. Loosen friction knob and position mounting arm.Tighten friction knob to lock arm in place.4. Connect mounting plate with 1/4”-20 threadedrod to mounting arm.ClampThe clamp can be attached to both flat or roundsurfaces.For round surfaces, make sure the clamp wedge isnot installed in the opening of the clamp. The clampwedge can be stored in the back of the clamp on thelocking screw when not being used.For flat surfaces, make sure the clamp wedge isinstalled in the clamp opening as shown in photo onthis page.Clamp wedge installedfor flat surfacesFriction knob1/4”-20 female thread for mounting plateLocking screwArm release buttonClamp securing handleClamp wedge removedfor round surfacesClamp wedge storage