AbleNet Linkable Quick Start Manual

AbleNet Linkable Quick Start Manual Manual pdf 1 page image

2 Link Receiver & Transmitter13Insert Batteries and Turn OnConnect Receiver & Activate Wireless Switch Latch & Timer (SLAT) Tricks, Tips, and WarrantyInsert two AA batteries into Receiver as shown on housing.Slide the power switch to the “On” position. The Receiver’s light(s)will activate briefly.When batteries are low, the device’s light will flash three (3) times.Select your Mode of Control by repeatedly pressing the “Mode” but-ton. The Receiver’s lights will indicate which mode is activated. ForTimed Modes - Adjust the Timer Dial from 1-60 seconds or minutesas desired.*Modes of ControlDirect Traditional switch behavior - device remainsON as long as switch is held.Timed Seconds Runs device from 1 to 60 seconds with eachactivation.Timed Minutes Runs device from 1 to 60 minutes with eachactivation.Latch First activation turns device ON; secondactivation turns it OFF.*PROGRAMMING TIP: Turn the Timer Dial all the way up to 60 andactivate the device. As the desired time approaches, turn the Dialback down towards 0, stopping the device at the time desired. Thefirst half-turn of the Timer Dial ranges from 1-10 sec./min. Thesecond half-turn ranges from 11-60 sec./min.Your Receiver has slots on the bottom of the device for mountingwith Velcro® straps. For additional mounting options, visitwww.ablenetinc.com.You can link up to 8 Transmitters to a Receiver using the linkablemethod explained in Step 2. When a Receiver’s light is green, anyactivated Transmitter will be linked. One Transmitter can also belinked to multiple Receivers at the same time.To unlink devices, press and hold the Receiver’s “Test” or “Mode”button for more than 10 seconds.To clean, wipe surfaces with a slightly damp cloth.Warranty InformationAbleNet manufactured products include a two-year limited war-ranty. This warranty is against defects in materials and manu-facturing for two-years from the date of purchase. Warranty infull text, along with return/repair information is available at www.ablenetinc.com. For more information on AbleNet products andservices, contact:AbleNet, Inc.Minneapolis/St. Paul, MN | 800-322-0956 | www.ablenetinc.comPlug the Receiver into any switch-accessible device or computerswitch interface.Activate the Transmitter.The Transmitter and Receiver will light red and the attached devicewill activate.NOTE: To test the physical connection with a switch-adapteddevice, press and hold the “Test” or “Mode” button for 2 seconds.1. With wireless Transmitter and Receiver turned on, press andhold the Receiver’s “Test” or “Mode” button until the light turnsgreen (about 5 seconds).2. Activate any Transmitter. The Receiver’s light will flash red 1time when a link has been established.*Link additional Transmitters by activating them now (optional).3. Press and release the Receiver’s “Test” or “Mode” button to exitlinking mode.Press & Hold5 secondsPress &ReleaseOnQuickstart Guide:Linkable™ Wireless Receivers andWireless Switch Latch and Timer (SLAT)www.ablenetinc.com700-05475A (07/09)

/ 4