Insert Battery and Turn On1 Record A Message2Erase A MessageLow Battery Indicator5Contact & Warranty InfoPlaying A Message3Erase A Message4Quick Start Guide: QuickTalker™ S1. Remove phillips screw andbattery door.2. Insert one 9-V battery andre-attach battery door andphillips screw.3. Slide power switch to on.1. Press record button and the visualfeedback light will turn red.2. Touch the activation area. Whenyou hear the auditory beep andthe visual feedback light startsto blink, begin recording yourmessage into the microphone.Touch the activation area again tostop recording.3. Repeat Step 2 for additionalmessages.4. When you are finished recording,press the record button again.1. To erase a message either record a new message over the existing message or hold therecord button for three seconds. You will hear an auditory beep when the message hasbeen erased.1. Touch the activation area to play message.2. Adjust volume up or down as needed.3. You will see the visual feedback light turn on when the activation surface is touched andmessage plays.Power ON/OFFBattery DoorVisual Feedback LightMicrophoneActivation AreaPN 98000034 Rev. B (07/2013)www.ablenetinc.comRecord ButtonVolumeThe following are indicators of a low battery and the battery should be replaced.1. Immediately after a message plays, the visual feedback light blinks red three times.2. A message begins to play, but stops before completely playing and the visual feedbacklight blinks red three times after the message stops playing.