Direct Control - Corded SwitchesPress to turn ON and release to turn OFF.See AbleNet website for a large selection of switches.Wireless ControlUsing a Wireless Switch and Receiver you can remotely activatethe toy.Attached the Wireless Receiver to the toy with a Velcro Strap.Note: Any switch become wireless by using the Switch Jack on thewireless switch.1. Insert a 3.5mm switch plug into Switch Jack.2. Turn product power ON3. Press and hold switch to activate toy.Using the ToyControlling the ToyQuickstart GuideSwitch Adapted Toyswww.ablenetinc.comThank you for purchasing a Switch Adapted Toy from AbleNet.Switch JackChanging the BatteriesSwitch PlugFor products with a Battery Device Adapter (BDA)1. Place the BDA between the neg (-) battery terminal andthe neg (-) battery contact.2. Align cable in Notch and close battery door.BDA CableNotchBDA(-) BatteryTerminalWarrantyToy warranty listed on packaging or 90 days.For more information on AbleNet products andservices, or for contact:AbleNet, Inc.Mpls./Saint Paul, MN 55113800-322-0956www.ablenetinc.comPN 900-80225 Rev. A (03/2011)www.ablenetinc.comProducts and AccessoriesLatched or Timed ControlUsing a Switch Latch and Timer with a switch will allow thetoy to stay activated without holding the switch.Latched - Press switch to turn the toy ON. Press the switchagain to turn the toy OFF.Timed Second and Minutes - Adjust the dial to select theamount of time the toy should stay on. Press switch toactivate for the selected duration.Note: Wireless Latch and Timed control is also available usingthe Wireless SLAT.ON OFFWireless ReceiverWireless SwitchSwitch JackVelcro StrapSwitch Latch & TimerTimer Setting Control ModeTimedTimed304560115 Sec. SMIMin.LatchWarranty and Contact InformationSwitch Latch & TimerSwitch Latch & Timer 100SSLAT JellyBeamer 10034200Wireless Receiver 10034400 BigBeamer 10033700Wireless SLAT 10034500 Velco Strap 80040100