1412. Internal activationIn addition to monitoring one or more partitions (i.e. objects or company departments) separately, the system also has an internal activation option. This type ofactivation is often used to monitor the exterior of the object when it is still occupied. In this case, specific detectors within the object such as motion sensors areremoved from surveillance. The same authorisations apply for internal activation as for any other activation. That means that only users who are authorised toactivate the entire system can internally activate an area. This also applies to remote controls.12.1. On the systemEnter your user code or hold your chip key overthe system reader. If you are authorised toactivate more than one partition, the followinggraphic display is shown:Select Part Set All and confirm by pressingSelect.All areas of the alarm system for which the usercode is authorised are now internally activated.The system emits the following acousticmessage:“Alarm system activated internally”To activate separate partitions internally, select“Partitions” until the following graphic display isshown:Select the partition to be activated.Change the settings for this partition.The displayed codes next to the partition havethe following meanings:Display MeaningU This partition remains deactivated.U>P This partition is activated internally.U>S This partition is activated.S>U This partition is deactivated.P>U This partition is deactivatedinternally.S This partition remains activated.P This partition remains activatedinternally.To activate one or more partitions internally,select U>P next to the corresponding partition.Confirm your entry by pressing Done.The system then carries out the entered actions(activation/deactivation). If only one partition isinternally activated, the system issues thefollowing message:“One partition activated internally”12.2. Using the wireless remotecontrolPartitions can be activated internally using thewireless remote control in two ways:a) The remote control internally activates allpartitions within the user’s authorisation.b) The keys of the remote control unit areprogrammed in the user menu to activateindividual partitions internally.Example of key settings:1) Complete activation(partitions 1 and 3)2) Complete deactivation3) System status4) Complete internalactivation5) Activate partition3 internallySee also “System Config”.2143142 5