12English1. Remove the rear cover of the door station.2. Attach the red cable for the round socket next to “DC+” in the terminal block.3. The black connecting cable for the round socket must be attached to the terminal point “DC-”.4. The two connecting cables for the cable lug must be inserted next to “UNLOCK”, with the terminals beingprovided for an existing 2-cable door opener connection.5. A round plug with a power supply unit can now be connected to the round socket.6. Turn on the power to the power supply unit.7. A door bell can be connected to the two uppermost connector points.Important:Please note that this contact is a potential-free relay contact, and a bell which lacks a powersupply of its own can therefore not be connected.Important:You also have the option of connecting your door opener directly to the door station, or toconnect an existing door opening transformer using a relay.Important:Please note that only DC door openers can be actuated, with AC door openers not being ableto be actuated.More Information: www.abus.com TVAC800206.2 Assembling the door station1. Use the door bracket to help you find a suitable place for installation. Use the drill holes to mark thesurface, and drill the holes. Insert the wall plugs provided before attaching the bracket using the screws.Important:Before starting the installation, make sure than the wireless transmission range at the site ofthe required installation is sufficient.Important:Before replacing the cover of the device, connect the door station to the monitor.2. Close the housing for the door station using the four screws provided.3. Place the door station into its housing and attach it using the anti-theft screws provided. The matchingscrewdriver has been enclosed with the package.