Abus TVVR20001 User Manual

Contents

Abus TVVR20001 User Manual Manual pdf 88 page image

PTZ control26PTZ SettingsThe following settings are necessary on the PTZ camera:The settings are used for configuring the camera on thecorresponding connections.1. Select the installed camera.2. Enter the data of the connected camera.3. The address (ID) is used to clearly identify and con-trol the PTZ camera.4. If several cameras of the same type are connected,then you can copy the settings to the other connec-tions.5. Exit the settings by pressing “Apply” and “OK”.NoteCompare the settings with the technical data ofthe connected camera.If a connected camera does not work correctly,then check the entered parameters (baud rate,data bit etc.).Preset SettingsPresets are previously defined locations of a PTZ cam-era. Various positions can be defined for each PTZ cam-era. The cameras can then pan and tilt quickly to the cor-responding locations. Select the camera in the control panel, then click on“Preset Settings” in the pop-up menu:1. Pan, tilt and zoom the camera to the desired posi-tion.2. Select “Preset 1” from the list.3. Click on “Set”. The position is now set as “Preset 1”.4. Repeat steps 1–3 to define further presets.5. Exit the settings by pressing “Apply” and “OK”.NoteWhen using ABUS PTZ-Cameras with the Pelco-D protocol some presets are predefined and can-not be used.Preset Beschreibung1~64,100~200Calls preset 1~64 &, 100~20065 Display preset Status66 Starts Auto Scan67 Auto Flip mode On/Off68 Camera reset69 Digital Slow Shutter functionOn/Off71~78 Calls tour 1~881~88 Calls pattern 1~891 Calls zero Position92 Freezes image93 BLC-Function On/Off94 Switches between day / night /auto mode95 Calls OSD menu96 Focus adjust97 Enable/Disable all alarmsFurther information can be found in the manual ofthe PTZ-Camera.