Chapter 3. Hardware Installation3.1. Install a 2.5'' HDDFollow the procedures below to install 2.5” SATA HDD into ARS-2000SUP.1. Remove the 4 screws of ARS-2000SUP and open the upper case.2. Slide the 2.5'' SATA hard drive along the sides of ARS-2000SUP till it connectsCN16.3. Fix the SATA hard drive to the two sides of ARS-2000SUP with the enclosed 4screws.10

copyright and trademarks

Chapter 1.About SCSIDE II

Chapter 2.Introduction

Package and Others

Chapter 3.Hardware Installation

Set the Jumper

Chapter 4.Troubleshooting

Chapter 5.Technical Support Form

Acard ARS-2000SUP User Manual

ARS-2000SUP


Contents copyright and trademarks Table Of Contents Chapter 1.About SCSIDE II Chapter 2.Introduction Package and Others Chapter 3.Hardware Installation Set the Jumper Chapter 4.Troubleshooting Chapter 5.Technical Support Form	Chapter 3. Hardware Installation3.1. Install a 2.5'' HDDFollow the procedures below to install 2.5” SATA HDD into ARS-2000SUP.1. Remove the 4 screws of ARS-2000SUP and open the upper case.2. Slide the 2.5'' SATA hard drive along the sides of ARS-2000SUP till it connectsCN16.3. Fix the SATA hard drive to the two sides of ARS-2000SUP with the enclosed 4screws.10 Previous Next / 14