Accelerated 6300-CX User Manual
Also see for 6300-CX: Customer Setup instructions
                               | |
Contents
| 
Accelerated Concepts, Inc. ©2015 6300-CX User’s Guide15 of 30ACCELERATED.COMTroubleshootingResetting Your DeviceTo reset the device to factory default settings, press the RESET/ERASE switch on the rear of the device. This will eraseall device specific settings and firmware updates and restore the device to its original firmware and settings.Establishing Backup Connectivity via Ethernet PortIf the device cannot connect using a cellular connection, use the following steps to use the Ethernet WAN connection.Restore the device to its factory default settings.Connect the Ethernet port of the device to the site network equipment/router. This may be done either directlywith an Ethernet cable or via the POE injector cable (6). Refer to the section “Using the Passive POE InjectorCable” above. Check for solid LINK and flashing ACTIVITY LEDs on the device WAN Ethernet port.The device will accept an IP address from the site network via its DHCP client.Observe the Status Indication LEDs & Signal Strength sections to aid in diagnosis.Note: Backup Connectivity via Ethernet Port and WAN connectivity via Ethernet Port features cannot be used at thesame time. If you use the steps listed here to set the device’s Ethernet port as a backup connection for itself,the 6300-CX will not be able to provide WAN connectivity to client device(s). |
Related manuals for Accelerated 6300-CX
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine