Site SurveySite SurveyA cellular site survey is not necessary if your anticipated installation location is known to havestrong cellular signal strength. If you are unsure of available cellular signal strength or arechoosing between several installation locations, follow the below instructions to perform a sitesurvey to determine your best possible installation location. After the optimal location has beendetermined, setup the 6330-MX with either the power supply unit or the PoE injector cable.1. Follow the steps in the “Initial Setup” section above. During a site survey it is useful to usethe included battery pack instead of the power supply unit to power the Accelerated6330-MX. The battery pack will power your device for approximately two hours while youperform your site survey. The battery pack is not rechargeable and should be properlydisposed of after use.2. Move the Accelerated 6330-MX to different locations within your site to determine the bestcompromise between signal strength and installation constraints. Since cellular signalstrength may fluctuate, it is important to wait at each location for 1 minute while observingthe signal strength indicator on the front of the device. Minimum cellular signal strength forproper operation is 2 bars.3. After the optimal location has been determined, remove the battery pack and connect eitherthe main power supply unit or PoE injector cable (see section labeled Using Remote Powerfor more information). After the optimal location has been determined, setup the 6330-MX with either the power supply unit orthe PoE injector cable.Site Survey TroubleshootingSite Survey TroubleshootingIf you are unable to verify a location with a strong cellular signal:• Verify your SIM has been activated with your cellular operator.• If cellular signal isn’t indicated on the Accelerated 6330-MX indoors, then take the deviceoutdoors to verify that your cellular network operator has coverage in your location.• If the outdoor cellular signal strength is less than 2 bars, it may be necessary to connectusing a different cellular network operator. This requires an activated SIM from the alternatecellular network operator.• Try the device/antennas in different orientations and away from other nearby electronicequipment at each test location. Note: LTE requires the use of both antennas & antennaswill usually give better performance when vertical.• Refer to the Device Status section to use Accelerated 6330-MX indicator lights to aid indiagnosis.Accelerated NoticesPage 19Page 196330-MX / 6335-MX