Acces PAD128 User Manual
                                       | |
Contents
| 
PAD128 ManualPage 6-2 Manual MPAD128.D1gBase Address + 0 Through Base Address + E (Even), Point SetupRegistersDF DE DD DC DB DA D9 D8 D7 D6 D5 D4 D3 D2 D1 D0SettleTime, use 0000 0 0timer0 CH-, use 000 CH+pauseloopThe highlighted bits are the ones you will use most often, the rest can be set to 0 fornormal operation.These eight word-sized registers contain the list of channels from which you wish toacquire data. The list is an ordered array of contiguous points, where the first entry (atbase+0) indicates the first channel you wish to acquire. The second entry (at base+2)through the eighth entry (Base+E) are optional and indicate further channels you wishto acquire in the order you wish to acquire them. No registers may be skipped. Forexample, if you wish to acquire channels 1 and 5, the entries would be set in Base+0 andBase+2, not base+4 and Base+A.The last channel's entry should have the loop bit (D0) set to allow the A/D to start overat the beginning of the list.Bits DF through DC, SettleTime, are optional, use 0000 for most input sources. If alarger settle time is desired, for example for source impedances (R) greater than 100ohms, the following equation will calculate the necessary setting for these bits (D):D = 3.33 x R (round up to nearest integer)Bits DB, DA and D8 are reserved for advanced functions. Refer to the LM12H458 chipspecification for more information.Bit D9 is the timer bit. When bit 9 is set to 1, the A/D chip will halt until the durationprogrammed in Base + 16 elapses. After the timeout elapses, operation will continueat the next point.Bits D7 through D5, CH-, select the low-side analog input channel. For single-endeduse, set these bits to 000. Any other setting configures the point for differential, wherethe values 001 through 111 indicate which channel (1-7) is to be used for the low sideof the differential analog input.Bits D4 through D2, CH+, indicate the high-side analog input channel. For mostapplications place a bit pattern from 000 to 111 to indicate which channel (0-7) youwant this point to acquire. When CH- is set to anything other than 000, CH+ selects thehigh side of the differential analog input channel. |
Related manuals for Acces PAD128
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine