IMPORTANTBefore assembling your ACCESS LIGHTING fixture, please make sure thatyou carefully read through these instruction sheets. Consider havingyour fixture installed by a qualified licensed electrician.NOTE: The important safeguards and instructions that appear in thismanual are not meant to cover all possible conditions and situationsthat may occur. It must be understood that common sense, caution andcare, are factors that can’t be built into any product. These factors mustbe supplied by the person(s) caring for and operating the fixture.STEP BY STEP INSTRUCTIONSBefore starting your installation disconnect the Power by turning off theCircuit Breaker or by removing the fuse at the fuse box. Just turning thelight off at the light switch is not sufficient to prevent electrical shock.MOUNT CROSSBAR AND WIRE CONNECTIONSI f there is an existing fixture remove it. Expose the supply wirefrom the J-box. Mount the crossbar to the J-box with thesupplied screws. Connect the black supply wire to the blackfixture wire. Secure with the supplied wire nuts. Connect thewhite supply wires to the white fixture wire. Secure with thesupplied wire nuts. Either wrap the green wire around one ofthe protruding screws or connect it to the supply ground wire.Secure all wire with electrical tape (not supplied).Tuck all wires carefully into the J-Box.1GENERAL INFORMATIONAll electrical connections must be in accordance with all ordinances,Local and National Electrical Codes. These fixtures are intended formounting to a standard 4” x 2 1/2”metal octagon outlet box. The boxmust be directly supported by the building structure and U.L. Recognized.WHAT YOU NEED• Screwdriver• Wire Cutters• Wiring Supplies as Specifiedby Electrical CodeINSTALLATION INSTRUCTIONSWHAT WE PROVIDE• Mounting Hardware• Crossbar• Fixture with Glass shade• LEDCOLLECTION1CERTIFICATION: UL WET NO. 20044LEDDMGAPPLICATION MODEL NO.Wall FixtureMIST 20043LEDDMG