Access Lighting 20370MG Installation & Operation Instructions

Access Lighting 20370MG Installation & Operation Instructions Manual pdf 1 page image

(4) PREPARE THE FIXTURE1. If you are replacing an existing fixture, disconnect andremove the old fixture. Expose the supply wiring from theoutlet box.2. Place the supplied long screws through the holes in thecrossbar and facing outward.3. Secure crossbar to outlet box with the supplied shortscrews. (The long screws should be facing out from thewall).4. Connect the Black wire from the fixture to the Black supplywire and the White fixture wire to the White supply wire,fasten securely with supplied wire nuts and secure wirenuts with UL listed electrical tape (not supplied). Tuck thewires carefully into the Junction box.5. Connect the ground wire from the fixture to the electricalsupply ground wire, or attach the ground wire directly tothe ground screw on the crossbar. Fasten securely withsupplied wire nuts and secure wire nuts with UL listedelectrical tape (not supplied). Tuck the wires carefully intothe Junction box.6. Put the long screws through the 2 holes allocated in thefixture back plate. Secure the fixture against the wall byscrewing on the supplied nut caps.7. Insert the bulbs. DO NOT EXCEED THE WATTAGE ASINDICATED ON THE WARNING LABEL.8. Place the metal frame over the glass diffuser (5) onto thefixture back plate and secure by screws at corners. Placefixture cover on top of metal frame and aligning the twoholes on the left and right hand side of the fixture. Securewith the supplied screws.9. It is strongly recommended that you caulk this fixturearound the back plate, where it makes contact with thewall.CAUTION: Ensure that the Fitting is Cool and Switched off,Before Changing Bulbs. Do Not use Bulbs Exceeding Maximum Wattage as PerCaution Label. Do Not Touch the Bulb while fixture is in operation. Do Not place fixture in close proximity to anycombustible material.***READ & SAVE THESE INSTRUCTIONS ***MODEL 20370MGINSTALLATION & OPERATION INSTRUCTIONS1) TOOLS AND MATERIALS REQUIRED Blade Screwdriver Adjustable Wrench Wire Cutters 2 x 60W/E-26/BulbsAttention:Before assembling your lighting fixture, please readthe following instructions.(2) GENERAL1. To ensure the success of the installation, be sure to read theseinstructions thoroughly before beginning.2. All electrical connections must be in accordance with local codes,ordinances, or the National Electrical Code. If you are unfamiliarwith methods of installing electrical wiring, secure the services of aqualified licensed electrician.3. These fixtures are intended for mounting to a standard 4” x 2 ¼ ”deep metal octagon outlet box. The box must be directly supportedby the building structure and must be U.L. Recognized4. Before commencing with the installation, disconnect the powerby turning off the circuit breaker or by removing the fuse at thefuse box. Turning the power off using the light switch is notsufficient to prevent electrical shock.NOTE:The important safeguards and instructions appearing inthis manual are not meant to cover all possible conditionsand situations that may occur. It must be understood thatcommon sense, caution and care, are factors that cannotbe built into any product. The person(s) caring for andoperating the fixture must supply these factors.(3) UNPACKING THE FIXTUREOn checking the contents of the box you will find;1. Universal Crossbar2. Fixture Assembly3. Mounting Hardware packet4. 1 x Glass Diffusers

/ 2

Related manuals for Access Lighting 20370MG