AccuEnergy AcuLink 810 User Manual
Also see for AcuLink 810: User manual
                                                                 | |
Contents
| 
V: 1.0 Revised: May. 201940Chapter 6: AcuLink 810 User interfaceBy default the WIFI mode is set for Access Point Mode, where the AcuLink 810 acts as a wire-less bridge allowing other wireless devices to connect.6.10.2 Ethernet 1The Ethernet 1 settings can be configured by selecting the 'Ethernet 1' tab on the NetworkConfigurations page.• Interface Status: Tells users whether there is an Ethernet cable connected or discon-nected to the Ethernet 1 port.• DHCP: Select 'Manual' to manually configure the IP address for Ethernet 1. If set to'Manual', users will also need to set the Subnet Mask and Gateway. Select 'Auto' to havethe AcuLink 810 assigned an IP address automatically. With this selection the SubnetMask, Gateway and will also be automatically assigned.• IP: If the DHCP is configured to Manual, the IP address can be configured.• Subnet: If the DHCP is configured to Manual, the Subnet Mask can be configured.• Gateway: If the DHCP is configured to Manual, the Gateway can be configured.www. .com information@itm.com1.800.561.8187 |
Related manuals for AccuEnergy AcuLink 810
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine