AccuWeb EVO 150 Instruction Manual
                                                                                                                                         | |
Contents
| 
Fieldbus Interface 103IntroductionThe Fieldbus Interface card permits an EVO 150 control system to communicate with a remotePLC or computer through a Fieldbus network.Interface cards are available for: EtherNet/IP, PROFINET IO, and Modbus/TCP.The Fieldbus interface provides full control of operating mode, guide point position, servo gain,and actuator speed limit; and permits monitoring of actuator position, end-of-travel status, andweb position.The Fieldbus interface may be used in conjunction with the front-panel switch pad.Contact AccuWeb, Inc. for the IP Configuration Utility and example Module Propertiesconfiguration.InstallationTo install the Fieldbus interface card in the EVO 150 controller, follow the steps below:1. Field installation of the Fieldbus interface card in the EVO 150 Controller:f) Verify that the power source is off and locked out.g) Install the Fieldbus interface card by pushing it firmly onto header P3 on the EVO 150controller assembly.h) Secure the Fieldbus interface card to the standoffs with four #4-40, 0.25” long machinescrews and four #4 internal tooth star washers provided.Note: If the control system is ordered with the Fieldbus interface card, these componentswill be factory installed and tested prior to shipment.2. Connections and settings:a) Install the Ethernet cable through an available cord grip. |
Related manuals for AccuWeb EVO 150
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine