|
18How to Clean and DisinfectThe dispenser should be cleaned and disinfected at least twice a year. More frequent cleaning anddisinfection may be required.WashingsolutionUse a scale remover that is not harmful to human body by diluting with water, and use moreamount if necessary.It is important to use the diluted cleaning solution immediately for safety and maximumeffect.Washingprocedure1) Shut off the water supply by locking the valve of the water line of the ice maker.2) Switch the ICE MAKING-OFF-WASH switch to the "WASH" position.3) The water in the water tank is drained through the evaporator cylinder and washing isdone by this (max. 5 minutes).4) Turn the ICE MAKING-OFF-WASH switch to "OFF" position.5) Remove all ice from the ice maker and reservoir.6) Pour the wash solution into the wash solution inlet until the evaporator assembly and thewater tank are full.7) (Until the wash solution overflows to the drain box)8) Leave the ice maker for 10 minutes before starting operation. If the water supply hose isclogged in step 7, remove it before operation.9) As described below, please disassemble and clean the water level sensor (high and low)if it is in bad water condition.10) If not, proceed to step 9.Ⓐ Remove the water level sensor from the water tank cover.Ⓐ Clean the level sensor with washing solution.Ⓐ Wash the water level sensor thoroughly with clean water.Ⓐ Fix the level sensor to the correct position.9) Switch the ICE MAKING-OFF-WASH switch to the " ICE MAKING" position to startthe ice maker. Keep it running until ice making stops.(※ Water supply valve should belocked so that water is not supplied.)11) 10) Switch the front ICE MAKING-OFF-WASH switch to the "WASH" position, and drainthe remaining water in the water tank and evaporator cylinders for 5 minutes.12) 11) Switch the ICE MAKING-OFF-WASH switch to the "OFF" position.13) 12) Open the water supply valve of the ice maker, and switch the ICE MAKING-OFF-WASH switch to the " ICE MAKING" position so that water can be supplied to the watertank.14) 13) When the geared motor is activated, switch the ICE MAKING-OFF-WASH switch tothe "WASH" position and drain the water (drain is possible for 5 minutes).14) Turn OFF the power switch and disconnect the power cord from the outlet.Please observe the following points.• Do not use ammonia-type detergents to prevent personal injury or damage to the ice maker.• Disinfection and cleaning should be handled according to the instructions provided.• Always wear protective eyewear and waterproof gloves to prevent skin or eye contact with water anddisinfectant.• After cleaning and disinfection, do not use ice made from cleaning agent and disinfectant. Be careful that nodisinfectant remains in the dispenser and any parts in the reservoir.
PreviousNext |