2.1.5 Plug the power cord into the outlet on the wall and check if the powerLED lights up. If it lights up, then the hub is ready to be connected to thenetwork, as shown in Figure 2-5.2.2 Installing the hub on your working surfaceYou have to find a solid working surface to place the hub and make sure theequipment is not close to any high voltage power source or over-heatedsources. Also keep away from electronic equipment sensitive to electronicinterference. The brief procedures of installing your hub should be:2.2.1 Put the hub on a stable working surface, as shown in Figure 2-6.2-4 User's ManualFigure 2-5 Power on the hub and make it ready