6-8User’s Manual6.4.2 Diskette DrivesThe default setting for Diskette Drive A is [1.44 MB 3.5-inch] andrefers to the floppy drive whether it is installed in the module bay orconnected externally via the parallel port. Diskette Drive B by default is setto [None], and is only enabled if two floppy drives are connected to thenotebook.6.4.3 Hard DisksThe Hard Disk 0 parameter is reserved for the hard disk. With thisparameter set to [Auto], the BIOS automatically detects the hard diskparameters and displays the formatted capacity in the parentheses right afterthe Hard Disk 0 parameter heading. It also displays the cylinder, head andsector values of the hard disk. Advanced hard disk settings are auto-configured by Setup for optimum drive performance.You can also choose to key-in the drive parameters by setting Hard Disk 0 to[User]. To determine your drive parameters, check the data found onyour hard disk or supplied in the hard disk vendor documentation. Wesuggest that you set this parameter to [Auto] to allow the BIOS to auto-detect the drive parameters at each boot-up.The Hard Disk 1 parameter is used when a CD-ROM drive module or futureIDE drive option is installed in the module bay. The default setting for bothparameters is [Auto].6.4.4 Num Lock After BootWhen enabled, Num Lock turns on after boot and the embedded keypadacts as a numeric keypad. The default setting is [Disabled].6.4.5 LCD Expansion ModeWhen enabled, the LCD screen shows in expanded mode. By default, thisparameter is set to [Disabled].
