Chapter 2 - BIOS Utility 2-72.2.11 Total MemoryThis parameter specifies the total amount of onboard memory. The memory sizeis automatically detected by BIOS during the POST. If you install additionalmemory, the system automatically adjusts this parameter to display the newmemory size.1st Bank/2nd Bank/3rd BankThe 1st Bank, 2nd Bank, and 3rd Bank parameters indicate the type and size ofDRAM installed in DIMM sockets 1, 2, and 3 respectively. The None settingindicates that there is no DRAM installed. For the location of the DIMM sockets,refer to Figure 1-1.2.2.12 Serial Port 1This parameter shows the serial port 1 address and IRQ setting. The default settingis 3F8h, IRQ 4.2.2.13 Serial Port 2This parameter shows the serial port 2 address and IRQ setting. The default settingis 2F8h, IRQ 3.2.2.14 Parallel PortThis parameter shows the parallel port address and IRQ setting. The defaultsetting is 378h, IRQ 7.2.2.15 PS/2 MouseThe BIOS utility automatically detects if there is a pointing device connected toyour system. If there is, this parameter displays the Installed setting. Otherwise,this is set to None. The default setting is Installed.
