Appendix A: ASM Pro quick installation guide136Software• Microsoft Windows 98, Microsoft NT Workstation 4.0, or Windows2000• ASM Pro 4.5 ConsoleConnecting communication peripheralsModemThe Server and the RDM Console communicate via modem protocol.Therefore, you need to connect an external modem with a baud rateof not less than 9600 baud to both systems. To connect an externalmodem, connect the RS232C serial cable to the modem data port andthe appropriate COM port of the system.Note: Use only modems that are purchased locally to ensurecompatibility with your telephone system. The modem must havea transfer rate of at least 28.8K.When the modem is turned ON, the CD/DCD (Carrier Detect/DataCarrier Detect) signal light on the front panel must be OFF for RDM tofunction properly. If this is not the case, refer to the modem's user'sguide and check the section on DIP switches for information on how toadjust the CD/DCD light. If your modem does not have a DIP switch,then we recommend that you replace it with another model thatsupports such switches.TelephoneTo connect the modem to a telephone outlet, plug in the telephoneconnector to the telephone outlet. Then, insert the telephone lineconnector to the modem line port.PagerThe pager is necessary for notification purposes only.Post-installation instructions.• Make sure the modem cables are properly connected.
