3 Hardware configuration50Closing the front subchassis and rearelectronics bayCaution! Before you close the front subchassis or electronics bay,make sure no cables are pinched or otherwise obstructing thefront subchassis and rear electronics bay. Excessive cable stress orchafing can cause cables to disconnect and connector pins to bendor break the cable insulation.To close the front subchassis and rear electronics bay1 To close the rear electronics bay:a Grasp the inside edge of the electronics bay and swing theelectronics bay into the main chassis.b Connect all cables to the mainboard.2 To close the front subchassis:a Grasp the edge of the front subchassis.b Depress and hold the spring clip (Figure 16, B) and swing thefront subchassis all the way into the main chassis.Figure 16 - Closing the front subchassis and rear electronics bay
