25Single CSM and TSM ConfigurationThis configuration can be cabled as either a Single (Joined) SCSI Bus oras a Dual (Split) SCSI Bus configuration.Cabling the single (joined) SCSI bus configurationOne host cable is required for this configuration. The length of thehost cable may be a maximum of 25 meters in length. When viewedfrom the rear there should be a CSM installed in one I/O slot and a TSMin the other.Follow the procedures below to connect the cable (see figure below):1. Power off the enclosure and the host system.2. Attach one end of the cable to the connector on the CSM.3. Attach the other end of this cable to the host.Note: For information on the host connectors, refer to thedocumentation supplied with it.12120I0ITo HostID 7CSM TSMMuteThe CSM and TSM can be in either I/O slot of the enclosure.SCSI ID Assignments shown from front of enclosure.
