Chapter 2 21LS-120 drive asThis parameter allows you not only to enable the LS-120 device installed in yoursystem, but also to specify the function of the device. The setting affects howBIOS will detect the device.Possible settings are:q Normal In this setting, BIOS does not support the LS-120 drive. The driveneeds the LS-120 device driver to operate.q Drive A BIOS recognizes the LS-120 drive as drive A. If a standarddiskette drive A exists, BIOS automatically identifies it as drive B.If two LS-120 drives exist, BIOS recognizes them as drive A and drive B,respectively.q Drive B BIOS recognizes the LS-120 drive as drive B.q Hard Disk BIOS recognizes the LS-120 drive as a hard disk. In thissetting, format the LS-120 drive as any other hard disk and assign it a driveletter C, D, E, and so on.IDE DrivesTo configure the IDE drives connected to your system, select the parameter thatrepresents the channel and port where the desired hard disk to be configured isconnected. The options are:IDE Primary Channel MasterThis parameter allows you to configure the hard disk drive connected to themaster port of IDE channel 1.IDE Primary Channel SlaveThis parameter allows you to configure the hard disk drive connected to theslave port of IDE channel 1.IDE Secondary Channel MasterThis parameter allows you to configure the hard disk drive connected to themaster port of IDE channel 2.IDE Secondary Channel SlaveThis parameter allows you to configure the hard disk drive connected to theslave port of IDE channel 2.
