Acer Aspire 7738 Series Service Manual

Also see for Aspire 7235 Series: Quick guide Service guide

Contents

Acer Aspire 7738 Series Service Manual Manual pdf 106 page image

98 Chapter 4Check the Battery PackTo check the battery pack, do the following:From Software:1. Check out the Power Management in control Panel.2. In Power Meter, confirm that if the parameters shown in the screen for Current Power Source and TotalBattery Power Remaining are correct.3. Repeat the steps 1 and 2, for both battery and adapter.4. This helps you identify first the problem is on recharging or discharging.From Hardware:1. Power off the computer.2. Remove the battery pack and measure the voltage between battery terminals 1(+) and 6(ground).3. If the voltage is still less than 7.5 Vdc after recharging, replace the battery.To check the battery charge operation, use a discharged battery pack or a battery pack that has less than 50%of the total power remaining when installed in the computer.If the battery status indicator does not light up, remove the battery pack and let it return to room temperature.Re-install the battery pack.If the charge indicator still does not light up, replace the battery pack. If the charge indicator still does not lightup, replace the DC/DC charger board.Touchpad CheckIf the touchpad doesn’t work, do the following actions one at a time to correct the problem. Do not replace anon-defective FRU:1. Reconnect the touchpad cables.2. Replace the touchpad.3. Replace the system board.After you use the touchpad, the pointer drifts on the screen for a short time. This self-acting pointer movementcan occur when a slight, steady pressure is applied to the touchpad pointer. This symptom is not a hardwareproblem. No service actions are necessary if the pointer movement stops in a short period of time.Power-On Self-Test (POST) Error MessageThe POST error message index lists the error message and their possible causes. The most likely cause islisted first.NOTE: Perform the FRU replacement or actions in the sequence shown in FRU/Action column, if the FRUreplacement does not solve the problem, put the original part back in the computer. Do not replace anon-defective FRU.This index can also help you determine the next possible FRU to be replaced when servicing a computer.If the symptom is not listed, see “Undetermined Problems” on page 112.The following lists the error messages that the BIOS displays on the screen and the error symptoms classifiedby function.NOTE: Most of the error messages occur during POST. Some of them display information about a hardwaredevice, e.g., the amount of memory installed. Others may indicate a problem with a device, such as theway it has been configured.NOTE: If the system fails after you make changes in the BIOS Setup Utility menus, reset the computer, enterSetup and install Setup defaults or correct the error.Downloaded from www.Manualslib.com manuals search engine