Machine Maintenance Procedures 3-5Machine Maintenance ProceduresIntroduction 0This chapter contains general information about the notebook, a list of tools needed to performthe required maintenance and step by step procedures on how to remove and installcomponents from the notebook computer.General Information 0The product previews seen in the following procedures may not represent the final productcolor or configuration. Cable paths and positioning may also differ from the actual model.During the removal and installation of components, make sure all available cable channelsand clips are used and that the cables are installed in the same position. All prerequisites mustbe performed prior to performing maintenance.Recommended Equipment 0The following tools are required to perform maintenance on the notebook:Wrist grounding strap and conductive matFlat screwdriverPhilips screwdriverScrew Table 0The following screw table provides a list of all required screws to assemble the computer.Table 1-1. Main Screw ListScrew Name QuantityM2.5x6.5 26M3.0x3.5 Ni 8M2.0x2.0 1M2.0x2.0 (Wide) 3M2.0x3.0 6M1.6x2.0 Ni 6M2.5x4.0 21M2.5x6.2 Ni 6
