|
90English Create factory default image CDWhen the System CD and Recovery CD are not available, you can create them byusing this feature.1 Boot to Windows XP.2 Press + to open the Acer eRecovery Management utility.3 Enter the password to proceed. The default password is six zeros.4 In the Acer eRecovery Management window, select Recovery settings andclick Next.5 In the Recovery settings window, select Burn image to disk and click Next.6 In the Burn image to disk window, select 1. Factory default image or2. Application CD and click Next.7 Follow the instructions on screen to complete the process.Note: Select 1. Factory default image when you want to burn abootable disk that contains your computer's entire operatingsystem as it was delivered to you from the factory. If you wish tohave a disk that will allow you to browse the contents and installselected drivers and applications, select 2. Application CD — thisdisk will not be bootable.Re-install bundled software without CDAcer eRecovery Management stores pre-loaded software internally for easydriver and application re-installation.1 Boot to Windows XP.2 Press + to open the Acer eRecovery Management utility.3 Enter the password to proceed. The default password is six zeros.4 In the Acer eRecovery Management window, select Recovery actions andclick Next.5 In the Recovery settings window, select Reinstall applications/drivers andclick Next.6 Select the desired driver/application and follow the instructions on screento re-install.At first launch, Acer eRecovery Management prepares all the needed softwareand may take few seconds to bring up the software content window. PreviousNext |