2-15 System UtilitiesDOS Flash UtilityNOTE:Plug the AC power adaptor to a power source before performing the DOS Flash Utility.Perform the following to use the DOS Flash Utility:1. Copy Flash.BAT to the USB HDD.2. Press F2 during boot to enter the BIOS Setup Utility.3. Select Boot menu to modify the boot priority order.4. Move the USB HDD to position 1 (refer to Boot on page 2-10).Figure 2:15. Changing the BIOS Boot Priority Order5. Insert the USB HDD and reboot the computer.6. Enter the BIOS folder.7. At the command prompt, type BIOS.bat and press Enter to update BIOS.Figure 2:16. Executing BIOS.BATIMPORTANT:• Ensure the AC power adaptor is connected to the power source.• Do not disconnect the AC power adapter.F9 Setup DefaultsF10 Save and ExitF1EscHelpExitSelect ItemSelect Menu EnterF5/F6Select Sub-MenuChange ValuesInsydeH20 Setup Utility Rev. 3.7MainItem Specific HelpUse <ʅ> or <ʆ> to select a device, thenpress to move it down the list, or to move it up the list. Press to escape the menuBoot priority order:1. HDD0 : Hitachi HTS545032B9A3002. ATAPI CDROM : MATSHITADVD-RAM UJ870BJ3. USB FDD :4. Network Boot : BRCM MBA Slot 0200 v15.0.115. USB HDD :6. USB CDROM :Information Security ExitBootC:\>BIOS.bat_
