Acer B196L User Manual

Contents

vampere rating of the equipment plugged into the extension cord does notexceed the extension cord ampere rating. Also, make sure that the totalrating of all products plugged into the wall outlet does not exceed the fuserating.• Do not overload a power outlet, strip or receptacle by plugging in toomany devices. The overall system load must not exceed 80% of the branchcircuit rating. If power strips are used, the load should not exceed 80% ofthe power strip's input rating.• This product's power cord is equipped with a three-wire grounded plug.The plug only fits in a grounded power outlet. Make sure the power outletis properly grounded before inserting the power cord plug. Do not insertthe plug into a non-grounded power outlet. Contact your electrician fordetails.Warning! The grounding pin is a safety feature. Using a poweroutlet that is not properly grounded may result in electric shockand/or injury.Note: The grounding pin also provides good protection fromunexpected noise produced by other nearby electrical devices thatmay interfere with the performance of this product.• Use the product only with the supplied power supply cord set. If you needto replace the power cord set, make sure that the new power cord meetsthe following requirements: detachable type, UL listed/CSA certified, typeSPT-2, rated 7 A 125 V minimum, VDE approved or its equivalent, 4.5meters (15 feet) maximum length.Product servicingDo not attempt to service this product yourself, as opening or removing coversmay expose you to dangerous voltage points or other risks. Refer all servicing toqualified service personnel.Unplug this product from the wall outlet and refer servicing to qualified servicepersonnel when:• the power cord or plug is damaged, cut or frayed• liquid was spilled into the product• the product was exposed to rain or water• the product has been dropped or the case has been damaged• the product exhibits a distinct change in performance, indicating a needfor service• the product does not operate normally after following the operatinginstructions