1FCC STATEMENTThis device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference thatmay cause undesired operation.Note:This equipment has been tested and found to comply with the limits for Class B digital devices,pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures:Reorient or relocate the receiving antennaIncrease the separation between the equipment and receiverConnect the equipment into an outlet on a circuit different from that to whichthe receiver is connectedConsult the dealer or an experienced radio/TV technician for helpUse of shielded cable is required to comply with Class B limits in Subpart B of Part15 of the FCC rules.Do not make any changes or modifications to the equipment unless otherwise specifiedin the manual. If such changes or modifications should be made, you could be requiredto stop operation of the equipment.