Acer HDS AMS200 Reference Manual

Acer HDS AMS200 Reference Manual Manual pdf 299 page image

Acer | HDS AMS200 User and Reference Guide 279Appendix B System Parameter Settings ListThe following table lists the parameter settings using the Storage Navigator-Modular.System Parameter1 System Startup Attribute Depends on System Configuration2 Drive Detach mode enable Disable (Standard setting)3 Turbo LU Warning Disable (Standard setting)4 Operation if the Processor failures Occurs Reset a Fault (Standard setting)5 ROM Microprogram Version No change is needed6 RAM Microprogram Version No change is needed7 Write & Verify Executing Mode On (Standard setting)8 DHCP (Note 2) OFF (Standard setting)9 Maintenance Port IP Address To be set according to the network setting10 IP Address To be set according to the network setting11 Subnet Mask To be set according to the network setting12 Default Gateway To be set according to the network settingHost Group1 LU Mapping Mode Depends on the System Configuration (Note 1)Target (Note 3)1 LU Mapping Mode Depends on the System ConfigurationNote 1: When the AMS200 is connected, the logical unit which is not wanted to be accessedby the port must be masked by means of the LU mapping mode.Note 2: When the DHCP mode is validated, the IP Address is acquired from the DHCP server.If the DHCP server is not started up or the DHCP function has been wrongly set, theacquisition of the IP Address will fail and the IP Address of the subsystem will remain“0.0.0.0”. (This is a state in which Storage Navigator-Modular or the Web cannot be used viaa LAN.)Note 3: Effective only when the iSCSI interface is added.