Acer P7500 Series User Manual

Also see for P7500 Series: User guide

36English Replacing the LampUse a screwdriver to remove the screw(s) from the cover, and then pull out thelamp.The projector will detect the lamp life. You will be shown a warning message"Lamp is approaching the end of its useful life in full power operation.Replacement Suggested!" When you see this message, change the lamp as soonas possible. Make sure the projector has been cooling down for at least 30minutes before changing the lamp.Warning: The lamp compartment is hot! Allow it to cool downbefore changing the lamp.To Change the Lamp1 Turn off the projector by pressing the power button.2 Allow the projector at least 30 mins to cool down.3 Disconnect the power cord.4 Find the "OPEN" button on side of the projector and push it to open thecover. (Illustration #1)5 Open the cover. (Illustration #2)6 Remove the two screws that secure the lamp module.(Illustration #3)7 Pull out the lamp module by force. (Illustration #4)To replace the lamp module, reverse the previous step.Warning: To reduce the risk of personal injury, do not drop thelamp module or touch the lamp bulb. The bulb may shatter andcause injury if it is dropped.LAMPTEMPSOURCERESYNCMENU1234