30EnglishAppendicesChanging the lampThe projector will detect the lamp life itself. It will show you awarning message “Lamp may fail soon ! Replacement Suggested !” When you see this message, change the lamp as soon aspossible.Make sure the projector has been cooled down for at least 30minutes before changing the lamp.Warning : Lampcompartment is hot!Allow it to cool downbefore changing lamp!Lamp Changing Procedure:1 . Turn off the power to the projector by pressing the Power/Standby button.2 . Allow the projector to cool down at least 30 minutes.3 . Disconnect the power cord.4 . Use screwdriver to remove the screw from the cover.Œ5 . Remove the cover.•6 . Remove the 2 screws from the lamp module.•7 . Pull out the lamp module.•To replace the lamp module, reverse the previous steps.Warning : Toreduce the risk ofpersonal injury, do notdrop the lamp moduleor touch the lamp bulb.The bulb may shatterand cause injury if it isdropped.1234